Safety Operating Procedures For Edge Grinding Machine

1. Before starting work, check the equipment to ensure it is in normal condition.
2. Operators must wear gloves and masks or dust prevention equipment. The doors and windows in the work area should be closed properly to prevent silica dust from escaping. The ventilation and dust removal device must be intact and effective.
3. Precautions for pre work inspection:
(1) The tightening nut of the grinding wheel must not be loose;
(2) The grinding wheel shall not have cracks or gaps;
(3) The safety cover is fully assembled and reliable;
(4) The front and rear, upper and lower transmission handles operate flexibly without any noise during operation.
4. When grinding the edges of steel plates, the adjustment size of the grinding wheel should be strictly controlled, and the grinding amount should not be too large at a time to avoid causing damage to the steel plate and breakage of the grinding wheel.
If there is a malfunction during grinding, such as the steel plate getting stuck, the main switch should be immediately turned off, and the steel plate should be removed after parking.
6. During production, always pay attention to checking whether the motor is heating up or running abnormally.
7. When stacking steel plates (especially cold-rolled plates and oil plates), pay attention to being neat, not skewed, not higher than 1.2 meters, and not colliding with each other to avoid slipping and injuring people.
8. When feeding and transporting steel plates, they should be held firmly and placed upright, and should not be thrown randomly to avoid injury.
When the ventilation and dust removal device fails, it should stop working or take measures.
10. After completing the work, turn off the switch and do a good job of cleaning.